No image available

How to Reflash Autel IM508 if Freezes Boot Logo?

If Autel MaxiIM IM508 screen freezes splash boot logo, you might need a firmware reflash.


reflash Autel IM508 Firmware 1



Here is the step-by-step guide on how to reflash Autel IM508 firmware:


Download Autel IM508 reflash files


reflash Autel IM508 Firmware 2





I.Set up Computer Circumstances

  1. Install RK driver

Open the folder “RK_DriverAssitant, run Driverintall.exe, following the on-screen prompts to install the driver.


  1. Install Google-USBdriver

Some computers may need to install this driver.


Open the folder “Google-USB_driver”;If your computer OS is 32-bit, run DPInst32.exeandif your computer OS is 64-bit, run DPInst64.exe.


If you have already installed this driver before, please go directly to next step.


II.Reflash the device

!!Attention: This procedure will format your device and will delete the data on your device. Backup data before operation.


  1. Run ReflasingTool

Open the folder “AndroidTool_Release_v2.1, run AndroidTool.exe, the reflashing window will be displayed as shown in the figure below.


reflash Autel IM508 Firmware 3


  1. Turn Your Device into Reflashing Mode

Connect your IM508 to computer with USB cable and wait until the computer recognizes the device.


You can check the connection status via Device Manager on your computer.

As it is shown in the red mark on the figure below, the device was already recognized by the computer.

reflash Autel IM508 Firmware 4

  1. Ready to Reflash.

Double click on the script named “reboot to loader.bat”;

reflash Autel IM508 Firmware 5

If it is run successfully, there will be a prompt message“Found One LOADER Device” displayed on the reboot window (as shown in the figure below).

reflash Autel IM508 Firmware 6

After you saw this message, click “Run” button to start and wait till rooting process is completed.

Leave a Reply

Your email address will not be published. Required fields are marked *