No image available

How to Clone Mercedes ME9.7 ECU using KESS3

Can Alientech KESS3 clone Mercedes ME9.7 ECU? via OBD or BDM?

 

Read Mercedes ME9.7 ECU with Alientech KESS3 1

 

Here is the clue.

No VR file at alientech, only option left is BDM.

 

Read Mercedes ME9.7 ECU with Alientech KESS3 2

 

 

If you have BDM adapter, follow kess v3 wiring diagram to read and write ME 9.7 via BDM.

Reading was a bit faster but the writing was really slow. Well over 30.
The old Kess v2 master version takes 45 minutes.

 

Read Mercedes ME9.7 ECU with Alientech KESS3 3

 

Read Mercedes ME9.7 ECU with Alientech KESS3 4

 

Read Mercedes ME9.7 ECU with Alientech KESS3 5

 

Read Mercedes ME9.7 ECU with Alientech KESS3 6

 

Read Mercedes ME9.7 ECU with Alientech KESS3 7

 

 

If currently don’t have an adapter for this ecu, just use needles or solder wires.

Found the pinout and soldering did the trick.

You have no issue with ID by obd. This ecu is a lot safer to do boot.

 

Read Mercedes ME9.7 ECU with Alientech KESS3 8

 

Read Mercedes ME9.7 ECU with Alientech KESS3 9

 

 

If you are looking for a tool to do it via OBD, go for original pcmflash.  (Clone pcmflash has no me9.7 in module 69).

Leave a Reply

Your email address will not be published. Required fields are marked *