No image available

Read and Write VAG Simos 18.10 by OBDSTAR DC706

OBDSTAR DC706 ECU cloning tool will read and write VW Audi Skoda Seat Porsche CONTINENTAL Simos 18.10 ECUs. Here is the instruction to read VW Simos 18.10 ECU in boot mode.

 

You will need:
OBDSTAR DC706
MP001 programmer with jumper cables
Simos 18.10 ECU

 

OBDSTAR DC706 Read and Write VAG Simos 18.1 ECU 1

 

 

Go to ECM, quick search Simos18.10
Select VW Continental Simos18.10 TC1791

 

OBDSTAR DC706 Read and Write VAG Simos 18.1 ECU 2

Check the introduction and wiring diagram

 

OBDSTAR DC706 Read and Write VAG Simos 18.1 ECU 3

Check ECU appearance, make sure it is identical to the image in DC706.

OBDSTAR DC706 Read and Write VAG Simos 18.1 ECU 4

Check boot connection diagram

Disassemble the ECU shell, solder the wires as shown in image, connect 1 GND, 2 C4-01 A1, C4-01 A2, C4-01 A3, C401-A4 pins

OBDSTAR DC706 Read and Write VAG Simos 18.1 ECU 5
Connect the harness according to the wiring diagram

OBDSTAR DC706 Read and Write VAG Simos 18.1 ECU 6

Set up connection with DC706, MP001 and Simos 18.1 ECU

 

OBDSTAR DC706 Read and Write VAG Simos 18.1 ECU 7

 

OBDSTAR DC706 Read and Write VAG Simos 18.1 ECU 8

 

Press Start
Selct Boot mode and MP001

OBDSTAR DC706 Read and Write VAG Simos 18.1 ECU 9

Connect ECM.

Read INT flash and save.

OBDSTAR DC706 Read and Write VAG Simos 18.1 ECU 10

Read INT eeprom and save

 

OBDSTAR DC706 Read and Write VAG Simos 18.1 ECU 11

 

Write INT Flash

Load external data

Load flash data you need to write.

OBDSTAR DC706 Read and Write VAG Simos 18.1 ECU 12

Write flash successfully.

Write INT eeprom.

Load eeprom you need to write.

OBDSTAR DC706 Read and Write VAG Simos 18.1 ECU 13

OBDSTAR DC706 Read and Write VAG Simos 18.1 ECU 14

Write INT eeprom successfully.

Press Disconnect.

Done.

Leave a Reply

Your email address will not be published. Required fields are marked *